ASI 3401-36 (36 x 1.25) Commercial Grab Bar, 1-1/4 Diameter x 36 Length, Exposed-Mounted, Stainless Steel

36-Inch Grab Bar

• Straight Design
• Exposed Flange - 3-Inch Diameter, 1/8-Inch Thick
• Type 304 Stainless Steel with Satin Finish
• Surface Mounted
• 1-1/4-Inch Outside Diameter Bar
• 36-Inch Length

The ASI 3401-36 is a straight grab bar that's 1-1/4 inches in diameter and 36 inches long. It has a smooth, satin finish made from 18-gauge stainless steel tubing. This finish not only reduces fingerprints but also gives it an appealing shine. At both ends, there are 3-inch diameter flanges made of type-304 stainless steel, herliarc welded to the tubing. Each flange has three 7/32-inch diameter countersunk, predrilled holes for No. 10 self-tapping or oval head mounting screws (not included). The holes are placed about every 120 degrees for a secure installation. Once installed, the mounting hardware is fully visible. This grab bar meets or exceeds all ADA requirements.

Using the ASI 3401-36 grab bar is simple. First, find a suitable place on the wall where you need support. Make sure the surface is flat and strong enough to hold the bar. Then, use the predrilled holes in the flanges to attach the bar to the wall with the appropriate screws (you'll need to buy these separately). When using the grab bar, hold it firmly to get the support you need. As for maintenance, just wipe it down with a soft, damp cloth regularly to keep it clean. Avoid using harsh chemicals as they might damage the satin finish. Also, check the screws from time to time to make sure they're still tight and the bar is securely mounted.