The ASI 3401-48P is a straight grab bar. It has a diameter of 1-1/4 inches and a length of 48 inches. The bar features a peened, non-slip surface for a secure grip. Crafted from 18-gauge stainless steel tubing, it has an appealing satin finish that reduces fingerprints while still looking shiny. At both ends of the grab bar, there are 3-inch diameter flanges made of type-304 stainless steel and securely welded to the tubing. Each flange has three 7/32-inch diameter countersunk, pre-drilled holes, spaced about 120 degrees apart, designed to fit No. 10 self-tapping screws or oval head mounting screws (not included). After installation, the mounting hardware is fully visible. This grab bar meets or exceeds all ADA requirements.


Using this grab bar is easy. Just decide where you want to install it, then use the pre - drilled holes in the flanges to attach it to the wall with the appropriate screws (not included). Make sure the surface you're mounting it on is flat and strong enough to hold the bar securely. When using the grab bar, hold it firmly to prevent slipping. For maintenance, clean the bar regularly with a mild soap and water solution. Avoid using abrasive cleaners as they may damage the satin finish. Check the screws periodically to ensure they're tight and the bar is still securely attached to the wall.