The ASI 3456-P is a top - notch horizontal grab bar. It has a 1 - 1/4 - inch diameter and a peened surface for a better grip. Measuring 54 inches by 36 inches, it's made from 18 - gauge stainless steel tubing with a nice satin finish. This finish not only reduces fingerprints but also gives it an appealing shine. At both ends and the angle, there are 3 - inch - diameter flanges. These flanges, made from type - 304, 11 - gauge stainless steel, are firmly herliarc welded to the tubing. Each flange has three 7/32 - inch - diameter countersunk, predrilled holes. They're spaced about every 120 degrees to ensure a super - secure installation. The mounting hardware stays fully visible after installation. This grab bar meets or exceeds all ADA requirements.
Using this ASI 3456 - P grab bar is easy. First, choose a suitable location on the wall. Then, use No. 10 self - tapping screws or oval head mounting screws (not included) to install it through the predrilled holes in the flanges. Make sure the screws are tightened properly for a secure fit. When using the grab bar, hold it firmly to support your body. As for maintenance, simply wipe it with a soft, damp cloth regularly to keep its satin finish clean and free of fingerprints. Avoid using abrasive cleaners as they may damage the surface. Also, check the mounting screws from time to time to ensure they're still tight and the grab bar remains secure.
