ASI 3501-12P (12 x 1.5) Commercial Grab Bar, 1-1/2 Diameter x 12 Length, Stainless Steel (Peened)

The ASI 3501 - 12P is a high - quality straight grab bar. It has a 1 - 1/2 - inch diameter and a length of 12 inches. The bar features a peened, non - slip surface, which provides a secure grip. Crafted from 18 - gauge stainless steel tubing, it has an appealing satin finish. This finish not only reduces fingerprints but also gives the bar an attractive shine. At both ends of the grab bar, there are 3 - inch diameter flanges made of type - 304 stainless steel, herliarc welded firmly to the tubing. Each flange has three 7/32 - inch diameter countersunk, predrilled holes. These holes are set about every 120 degrees and are designed to fit No. 10 self - tapping screws or oval head mounting screws (not included). Once installed, the mounting hardware stays fully visible. This grab bar meets or exceeds all ADA requirements for grab bars, ensuring safety and reliability.

Using this grab bar is easy. First, decide where you want to install it. Then, use the predrilled holes in the flanges to attach it to the wall with No. 10 self - tapping screws or oval head mounting screws (you'll need to buy these separately). Make sure to place the screws evenly according to the 120 - degree spacing of the holes for a secure fit. When using the grab bar, hold it firmly on the non - slip peened surface to avoid slipping. As for maintenance, wipe it regularly with a soft cloth to keep the satin finish looking good and to prevent fingerprints. Avoid using abrasive cleaners as they may damage the finish. If you notice any loose parts or damage, check the installation and make repairs as needed. This grab bar is built to last, but proper care will ensure it serves you well for a long time.