ASI 3704-RP (32 x 16 x 1.25) Commercial Right Hand Grab Bar, 1-1/4 Diameter x 32 Length, Stainless Steel (Peened)

The ASI 3704-RP is a 90-degree right-side grab bar. It has a 1-1/4-inch diameter and a peened surface for a better grip. Measuring 16 inches by 32 inches, it's made from 18-gauge stainless steel tubing with a lovely satin finish that resists fingerprints while adding a nice shine. The grab bar has 3-1/8-inch diameter flanges at both ends and the angle. These flanges are crafted from 1/8-inch thick type-304 stainless steel and are securely welded to the tubing. There are also three snap-on flange covers made of 22-gauge type-304 stainless steel. With a 3-3/16-inch diameter, these covers slide down and snap over the flanges after installation, hiding the mounting hardware and protecting the bar from tampering and vandalism.

Using this grab bar is easy. Just install it on the right - hand side of the area where you need support. Make sure to follow the installation instructions carefully to ensure it's securely in place. When using, simply hold onto it firmly for balance. As for maintenance, you can clean it with a mild soap and water solution. Avoid using abrasive cleaners as they may scratch the satin finish. Check the flange covers regularly to ensure they're snapped on properly. If you notice any signs of damage to the grab bar or the flanges, replace them immediately to maintain safety.