The ASI 3804-LP is a 90-degree left-hand grab bar with a 1.5-inch diameter. It features a peened surface for a better grip. Measuring 16 by 32 inches, this grab bar is crafted from 18-gauge stainless steel tubing with an appealing satin finish. This finish not only reduces fingerprints but also gives the bar an attractive shine. At both ends and the angle, there are 3.125-inch diameter flanges made of 1/8-inch thick type-304 stainless steel, securely welded to the tubing. The grab bar comes with three snap-on flange covers made of 22-gauge type-304 stainless steel. These 3.1875-inch diameter covers slide down and snap over the flanges after installation, hiding the mounting hardware, protecting the bar from tampering and vandalism.


Using the ASI 3804-LP grab bar is simple. Just hold onto it firmly for support. It's designed for left-side use, so make sure it's installed on the correct side. When installing, place the grab bar where you need it and use the provided mounting hardware. After installation, slide the flange covers over the flanges until they snap into place. This will not only make it look nicer but also protect the hardware. For maintenance, clean the grab bar regularly with a mild soap and water solution. Avoid using abrasive cleaners as they can scratch the surface. If you notice any damage or loose parts, check the mounting and the bar itself. Replace any parts if necessary to keep the grab bar safe and functional.