The ASI 3402-52P is a top - notch straight grab bar with a 1 - 1/4 - inch diameter. With an intermediate support for extra strength, it spans 52 inches and has a sleek, smooth finish. Crafted from 18 - gauge stainless steel tubing, it boasts an alluring satin finish. This finish not only reduces fingerprints but also gives the bar an eye - catching shine. At both ends and the center of the grab bar, there are 3 - inch - diameter flanges made from type - 304 stainless steel, firmly welded to the tubing using herliarc welding. Inside each flange, there are three 7/32 - inch - diameter countersunk, predrilled holes. These holes are designed to fit No. 10 self - tapping screws or oval head mounting screws (not included), spaced about 120 degrees apart for a super - secure installation. Once mounted, the hardware stays fully visible. This grab bar meets or surpasses all ADA - established requirements for grab bars.
Using the ASI 3402 - 52P grab bar is simple. First, gather the No. 10 self - tapping screws or oval head mounting screws you'll need (they're not included). Line up the predrilled holes in the flanges with the spots on the wall where you want to install the bar. Insert the screws and tighten them securely. Make sure to keep the bar level as you're installing it. As for maintenance, since it has a satin finish that resists fingerprints, a simple wipe with a damp cloth will usually do the trick. Avoid using abrasive cleaners as they might damage the finish. If you notice any loose screws over time, just tighten them up to keep the bar secure. And remember, this grab bar meets ADA requirements, so you can trust it for reliable support.
