ASI 3501-48 (48 x 1.5) Commercial Grab Bar, 1-1/2 Diameter x 48 Length, Exposed-Mounted, Stainless Steel

The ASI 3501-48 is a straight commercial grab bar crafted from 18-gauge stainless steel tubing. It has a smooth and attractive satin finish that not only reduces fingerprints but also gives it a lovely shine. Measuring 1.5 inches in diameter and 48 inches long, this grab bar is built to last. At each end, there's a 3-inch diameter flange made of type-304 stainless steel, securely welded to the tubing. Inside each flange, you'll find three 7/32-inch diameter countersunk, predrilled holes, spaced about 120 degrees apart. These holes are designed to accept No. 10 self-tapping screws or oval head mounting screws (not included). Once installed, the mounting hardware remains fully visible. This grab bar meets or exceeds all ADA requirements for grab bars, ensuring safety and reliability.

Using the ASI 3501-48 grab bar is simple. First, gather your No. 10 self-tapping screws or oval head mounting screws (not included). Then, align the flange holes with the desired mounting surface and insert the screws to secure the grab bar. Make sure it's firmly attached for your safety. When using the grab bar, hold it firmly with your hand for support. As for maintenance, you can clean it with a mild soap and water solution. Avoid using abrasive cleaners as they may scratch the satin finish. Regularly check the screws to ensure they're tight and the grab bar is secure. If you notice any signs of damage or looseness, replace or repair it immediately.