ASI 3550 (36 x 24 x 1.5) Commercial Grab Bar, 1-1/2 Diameter x 36 Length, Exposed-Mounted, Stainless Steel

The ASI 3550 is a high - quality horizontal grab bar. It has a 1.5 - inch diameter and a smooth finish. Measuring 24 inches by 36 inches, this grab bar is crafted from 18 - gauge stainless steel tubing. The tubing has an appealing satin finish that not only reduces fingerprints but also gives the unit an alluring shine. At both ends and the angle of the unit, there are 3 - inch diameter flanges. These flanges are made from type - 304, 11 - gauge stainless steel and are firmly herliarc welded to the tubing. Inside each flange, there are three 7/32 - inch diameter countersunk, predrilled holes. These holes are designed to accept No. 10 self - tapping screws or oval head mounting screws (not included). With one hole positioned every 120 degrees, it ensures a super - secure installation. Once mounted, the mounting hardware stays fully visible. This grab bar meets or exceeds all ADA - established requirements for grab bars, providing safety and reliability.

Using the ASI 3550 grab bar is easy. First, find a suitable location on the wall where you need support. Mark the spots for the holes on the wall according to the predrilled holes on the flanges. Then, use No. 10 self - tapping screws or oval head mounting screws (not included) to secure the grab bar to the wall. Make sure to tighten the screws well for a stable installation. When using the grab bar, hold it firmly for support. For maintenance, simply wipe it with a soft, damp cloth regularly to keep its satin finish clean and shiny. Avoid using abrasive cleaners as they may damage the surface. Also, check the screws periodically to ensure they remain tight and the grab bar stays secure.