The ASI 3860 is a top - notch horizontal grab bar. It has a 1.5 - inch diameter and a smooth finish. Measuring 30 inches by 18 inches, this grab bar is crafted from 18 - gauge stainless steel tubing. The tubing has a lovely satin finish that not only reduces fingerprints but also gives it an appealing shine. At each end, there's a 3 1/8 - inch diameter flange made of 1/8 - inch thick type - 304 stainless steel, firmly welded to the tubing. It comes with a pair of snap - on flange covers made of 22 - gauge type - 304 stainless steel. These 3 3/16 - inch diameter covers slide down and snap over the flange after installation, hiding the mounting hardware, protecting the grab bar from tampering and vandalism.
Using the ASI 3860 grab bar is easy. Just make sure it's installed in a proper place where you need support. When installing, carefully place the flange covers over the flanges and snap them on. As for maintenance, you can clean it with a mild soap and water solution to keep the satin finish looking great. Avoid using abrasive cleaners as they might scratch the surface. Also, regularly check the mounting hardware to ensure it remains secure. If you notice any signs of damage or loosening, take action right away to keep the grab bar safe and reliable.
