This sanitizing station is crafted from 5/8″ plastic laminate with antimicrobial features and a Cosmic Strandz finish. It's freestanding, which means you can easily place it wherever you need and move it around. All edges and corners are rounded for safety, and the bottom has rubber feet to stop it from sliding. The back door is locked with a key, giving you access to the dispenser components. The station comes fully assembled, and the included 0390 - HSD hand sanitizer dispenser is installed on - site. The 0390 - HSD Gel Hand Sanitizer Dispenser offers touchless operation. When the sensor under the dispenser is triggered, a single dose of gel hand sanitizer is automatically dispensed by a battery or AC - powered mechanism. It has a polished chrome finish on all visible surfaces and can hold 1.6 Gal (6L) of sanitizer. To use this dispenser correctly, only gel hand sanitizer with a viscosity between 3.5k – 6.5k mPa·s (or cP) and a pH range of 5.5 to 8.5 should be used. A full dispensing chart and other technical documents are available for all dispensers. There are two models: the FS - 0700A runs on batteries, and the FS - 0700AC is AC - powered.
Using your ASI FS - 0700A sanitizing station is a breeze. First, find a good spot for it. Since it's freestanding and mobile, you can put it anywhere you want. Make sure the rubber feet are on a flat surface to prevent it from sliding. To access the dispenser components, use the key to open the back door. When it comes to the hand sanitizer dispenser, just wave your hand under the sensor. It will automatically give you a single shot of gel hand sanitizer. Remember, only use gel hand sanitizer with a viscosity between 3.5k – 6.5k mPa·s (or cP) and a pH range of 5.5 to 8.5. For maintenance, keep the station clean by wiping it with a soft cloth. Check the battery regularly if you have the FS - 0700A model. And don't forget to refer to the dispensing chart and other technical documents if you have any questions.
